Short answer
Fine pale speckling on a calathea leaf, with dusty-looking silk underneath, is usually the twospotted spider mite, Tetranychus urticae, which feeds from the abaxial (lower) leaf surface and empties mesophyll cells one puncture at a time [1]. UF/IFAS notes that calatheas also exude a sticky film where these mites feed [3]. Control means rinsing or spraying the undersides thoroughly, repeating on a cycle shorter than one mite generation, and correcting the warm, dry, bright conditions that favour the mite [1][2][4].
What does spider mite damage look like on a calathea?
The first sign on a calathea (the trade name for most species now placed in Goeppertia) is stippling: tiny pale dots scattered over the adaxial (upper) surface while the mites themselves sit on the abaxial (lower) surface. The twospotted spider mite, Tetranychus urticae, feeds by piercing plant tissue with needle-like mouthparts and lives mainly on the leaf underside [1]. Each puncture drains sap, the mesophyll (the green photosynthetic tissue between the two leaf skins) collapses, and a small chlorotic spot forms at that feeding site; UF/IFAS estimates that 18 to 22 cells are destroyed per minute [1]. On a patterned calathea such as Goeppertia makoyana or G. ornata, the stipple is easiest to see on the plain green zones between the painted bands, where the contrast is highest.
As feeding continues the stippling merges into a bleached, then yellow, grey or bronze cast, and heavily attacked leaves can drop [1][2]. Three further clues are specific to Marantaceae production experience. The UF/IFAS Calathea production notes record that affected plants turn yellow or speckled and that the plant responds to mite feeding by exuding a sticky substance that can build up in large quantities on the lower leaf surface [3]. The same notes warn that cast skins and webbing are often mistaken for dust on the leaf underside [3]. And the leaf usually curls as the punctured blade loses water, which is why a spider mite problem is often first noticed as curling rather than as mites.
Is it the twospotted spider mite or the Marantaceae tarsonemid mite?
Calatheas have a second, much smaller mite that the twospotted spider mite is easily confused with in conversation but not on the leaf. Steneotarsonemus furcatus is a tarsonemid (a family of minute mites that live in folded and unopened tissue) whose recorded hosts are Calathea spp., Maranta spp. and the grass genus Paspalum [6]. The Florida Department of Agriculture circular that describes it on these plants reports that, before Maranta and Calathea leaves unfold, the mites begin feeding at the leaf tip, and that early injury shows as water-soaked bands 5 to 10 mm wide along the midrib [6]. UF/IFAS lists it separately from the twospotted spider mite as a serious calathea pest that goes unnoticed until plants are badly damaged [3].
The two are separated by where and when the damage appears:
- Twospotted spider mite: fine stippling on fully opened, older leaves; silk on the abaxial surface; mites visible with a 10x lens.
- Tarsonemid mite: water-soaked bands and tip necrosis (dead brown tissue) on leaves that are still rolled or have just opened; no webbing; mites too small to see without a microscope [6].
If the damage is concentrated on the newest scroll of a calathea, read the page on new leaves that will not unfurl before treating for spider mites, because the tarsonemid and thrips are the more likely causes there.
Why do calatheas indoors attract spider mites?
Goeppertia species are understory herbs of neotropical forest, and the conditions a calathea is adapted to (shade, constantly moist soil, humid air) are close to the opposite of what Tetranychus urticae prefers. The mite favours hot, dry weather [1], and UC IPM notes that damage is usually most severe in hot, dusty conditions and on water-stressed plants [2]. A calathea on a sunny windowsill or above a heating vent therefore combines a host under stress with an environment ideal for the pest. UF/IFAS makes the same link in its sheet on peacock plant (Goeppertia makoyana, still listed there as Calathea makoyana): mites can be a serious pest problem, particularly if the plant is in a sunny location [4].
Where the colony sits matters too. Calathea blades are held near horizontal on long petioles, and in many cultivated species the abaxial surface is purple; UF/IFAS records purple lower leaf surfaces for C. insignis and C. majestica among others [7]. Owners look at the painted upper surface, and the mites live on the side that is rarely turned over. NC State's Plant Toolbox lists spider mites with aphids, scale and mealybugs as the potential insect pests of Goeppertia grown indoors [8]. In production, UF/IFAS traces mite infestations mostly to bringing infested plant material into the growing area [3], so a newly bought calathea is the most common entry point for mites into a collection.
How fast does a spider mite colony build on a calathea?
Fast enough that a weekly glance can miss the whole build-up. At about 80 F, Tetranychus urticae completes development from egg to adult in five to twenty days, and each adult female lives two to four weeks and can lay several hundred eggs [1]. The life cycle runs egg, six-legged larva, two eight-legged nymphal stages (protonymph and deutonymph), then adult [1]. Indoor calatheas are kept warm all year, so there is no winter break in reproduction, and generations overlap so that eggs, nymphs and adults are present at once.
That overlap is the reason single treatments fail. UF/IFAS notes that most miticides do not kill eggs, so two or more applications are needed at five-day intervals in summer or seven-day intervals in winter [1]. The same logic applies to soap, oil and water rinses on a calathea: each pass removes the active stages, and the next pass has to arrive before the eggs that survived have grown into egg-laying females.
Does misting or raising humidity stop spider mites?
It helps the plant more than it harms the mite. UF/IFAS guidance for interior calatheas is to keep relative humidity between 40% and 60% to maintain appearance [7], and a calathea at the upper end of that range loses less water through punctured tissue, so damage shows less. But laboratory work on spider mite eggs shows why humidity is not a cure. Ubara and Osakabe (2015) held Tetranychus and Panonychus eggs at high humidity or under water and found that hatching was delayed rather than prevented: once humidity dropped, many eggs hatched within 1 to 3 hours [5]. In Tetranychus urticae the delay was variable, and high humidity affected but did not suppress larval development [5].
For a calathea owner the practical reading is that a humid room slows a spider mite outbreak and reduces leaf damage, while the colony itself has to be removed physically or with a contact treatment. Misting that wets only the adaxial surface does nothing to colonies on the underside.
How do you clear spider mites from a calathea?
- Confirm the mite. Check the abaxial surface of a stippled calathea leaf with a 10x to 15x lens for mites, cast skins and webbing, or hold white paper under the leaf and tap it sharply so mites drop onto it [1][2].
- Isolate and rinse. Move the plant away from other Marantaceae and rinse both leaf surfaces with a forceful spray, paying most attention to the underside. UC IPM notes that regular forceful water sprays alone often reduce spider mite numbers adequately on small plants [2].
- Use contact products on the underside. Insecticidal soap or horticultural oil kills only the mites it touches, so excellent coverage of leaf undersides is essential and repeat applications may be required [2]. UC IPM advises against using soaps or oils on water-stressed plants or when temperatures exceed 90 F [2]; water a dry calathea the day before spraying and test on one leaf first, because plant varieties differ in their susceptibility to soap and oil burn [1].
- Repeat on the egg cycle. Treat again every five to seven days for at least three rounds, matching the interval UF/IFAS gives for miticides [1].
- Consider predatory mites for a collection. Phytoseiulus persimilis preys on all stages of the twospotted spider mite and can consume 20 eggs or five adults a day [1]; UC IPM's rule of thumb is one predator for every 10 spider mites [2]. UF/IFAS cautions that biological control of mites on calatheas has worked in small-scale studies but is unproven in commercial greenhouses [3].
- Fix the conditions. Move the calathea out of direct sun and away from heat sources, keep the root zone evenly moist, and keep humidity toward the upper part of the 40% to 60% band [4][7].
Stippled calathea tissue will not regain its colour; success shows as new leaves that open clean. UC IPM also warns that broad-spectrum insecticides such as some pyrethroids often trigger spider mite outbreaks by killing their predators [2].
Frequently asked questions
Are the white dots on my calathea always spider mites?
No. Thrips also stipple leaves but leave black specks of excrement and no silk, and the Marantaceae tarsonemid mite causes water-soaked bands on new leaves rather than dots on old ones [6]. Silk and moving specks on the leaf underside point to Tetranychus urticae [1].
Why is the underside of my calathea sticky if it has spider mites?
UF/IFAS records that calatheas respond to spider mite feeding by exuding a sticky substance that can accumulate in large amounts on the lower leaf surface [3]. Stickiness without mites is more often honeydew from mealybugs or scale.
Which calatheas are most prone to spider mites?
No ranked susceptibility study for Goeppertia species was located. UF/IFAS singles out peacock plant, Goeppertia makoyana, as prone to serious mite problems in sunny positions [4], and any calathea kept warm, bright and dry is at higher risk [2].
Can a calathea recover from a bad spider mite infestation?
Usually, if the rhizome and roots are healthy. Damaged leaves stay stippled, but a Goeppertia replaces foliage from its rhizome, so once mites are cleared and repeat treatments have caught the hatching eggs, new leaves open clean [1][7].







