Short answer
A mounted hoya grows on a slab of cork, tree fern, wood or fibre instead of in a pot. Published growers report success with Hoya curtisii, H. lacunosa, H. imbricata and others [1][5]. Antone Jones ties cuttings over damp sphagnum with fishing line at the nodes [1]; Ted Green mounted H. imbricata without moss [5]. Green and an orchid index report that mounts dry quickly [3][8], and Jones found pots easier for growers in arid regions [2].
What is a mounted hoya, and who grows them that way?
A mounted hoya is grown attached to a slab of bark, wood, tree fern or fibre instead of planted in a pot, with its roots on the surface of the mount. The Royal Horticultural Society notes that in the wild hoyas often grow as epiphytes, on tree branches or in bark [9]. This page collects what published growers report about doing it. The epiphytic ecology guide covers the wild habit and the climbing support page covers trellises and hoops; neither is repeated here.
The accounts used here come from two hoya journals, Fraterna and Stemma, and an index of orchid literature. Ted Green, who ran the nursery Green Plant Research in Hawaii, told Fraterna in 1992 that besides pots from 4 inches to 3 gallons he grew plants on redwood boards, tree fern and cork bark without pots at all [4]. Antone Jones, writing on mounting Dischidia (a genus he describes as closely related to Hoya) in Stemma in 2007, added that some hoyas also make great mounting subjects and named Hoya curtisii, H. retusa, H. wayetii, H. lacunosa and H. picta as doing quite well mounted [1]. Gerbrand Caspers, describing the hoya collection at the Hortus Botanicus in Leiden in Fraterna in 2007, saw several hoyas mounted on fibre mats, among them H. caudata, H. longifolia, H. tsangii and H. lacunosa, all in very fine condition [5].
Which mount materials have growers used?
Jones listed cork, driftwood or a tree fern slab as the base for a mount, and used cork bark in his worked example [1]. Green mounted the small-leaved plant he called Hoya pruinosa, which the bulletin's editor noted she had bought from Green Plant Research as H. curtisii, on a slab of redwood bark 4 by 12 by 1/2 inch, held upright in a 5 inch cement pot with crushed gravel, and wrote that plants of this growth type do very well mounted on tree fern, bark or a log [3]. For Hoya imbricata he suggested a 12 inch length of oak, tree fern or cork, 4 inches in diameter [5]. At Leiden the mounts were pressed coco fibre mats, 5 by 5 by 40 cm, cut from plates 40 by 60 cm and hung from wire hooks [5].
Orchid literature reports a similar range of materials and some disagreement. The Orchid Doctor, an index of orchid advice compiled by Robert M. Hamilton and posted on orchids.org, cites a culture manual for angraecoid orchid growers listing slabs of cork bark, sassafras wood, aged hardwood and western cedar, and coconut husks, among mount materials [8]. One entry reports a collection of 40,000 orchids moved from pots to cork mounts with great success, and rates Hawaiian tree fern and a local Californian oak as bad mount materials [8]. Green suggested both tree fern and oak for H. imbricata [5]. The Orchid Doctor entries are orchid records, and the sources do not settle which material suits which hoya.
How is a cutting attached to a mount?
Jones's 2007 method for Dischidia is the most detailed published step-by-step account, and he extended it to hoyas [1]. His materials were damp long-fibred sphagnum moss, needle-nose pliers, orchid basket wire for the hook, 40 lb test fishing line and the mount itself [1]. He soaked the sphagnum in a very dilute solution of orchid fertilizer, tied the line around the back of the mount with a strong knot, then laid the moss on the front [1]. He chose 40 lb line because thinner line can cut through the plant when tightened, while thicker line is hard to knot [1].
The cuttings went on top of the moss, with their tops flush with it so that every node could be used, and the line was wrapped around the cuttings, always securing it at the nodes because, as he wrote, the node is where the roots come from [1]. A final knot at the back held everything snug but not overly tight, to avoid breaking the line or damaging the cuttings [1]. For the hook he made a small hole at the top of the mount, using a small drill on cork or driftwood, and bent the wire into a hook [1].
Green placed his cuttings differently. For Dischidia he suggested attaching the cutting to the bottom of a slab of cork or rough wood and hanging it up, so that water drains to the bottom and the plant grows up toward the top [6]; his advice for Hoya imbricata was the same, attaching the plant to the bottom of the length of wood [5].
Moss on the mount, or bare wood?
The grower sources disagree, and the disagreement is reported here as published. Jones placed a good amount of sphagnum so that the mount would be easy to keep evenly moist but not so much that it stayed too wet for too long, and kept the moss damp but not wet [1]. He wrote that the sphagnum only lasts about one or two years and may need replacing [1]. Green used a bit of New Zealand sphagnum moss to get the original cutting of his H. pruinosa started, with no potting material afterwards, and noted that the moss eventually rots and falls away [3].
For Hoya imbricata Green went further: no moss is necessary under the leaf or around the stem [5]. Writing on Dischidia in 2005, he advised that if a basket is used instead, sphagnum moss should be left out because it retains too much water and salts [6]. A grower in Fraterna in 1997 reported growing the same species with sphagnum: H. imbricata attached to tree fern wrapped with sphagnum, set on clay pebbles in a large, partly open zip-lock bag a few inches from grow lights, was the first time a start of it had grown [7]. The 1997 account describes an indoor grow-light setup; the sources do not compare it with Green's advice.
How often do mounted hoyas need water, light and feeding?
Grower accounts describe mounts that dry quickly. Green wrote that his mounted H. pruinosa plants dry out quickly because they have good drainage and sit where air movement is good, in 50 percent sunlight [3]. That plant was watered about three times a week with a weak fertilizer solution and flowered 30 months after it was started from a small 4 inch cutting [3]. He gave his own conditions alongside: in Kaaawa the temperature is never below 58 F or above 91 F and the humidity is always 50 percent or more [3].
At Leiden, Caspers recorded that the hoyas were watered thoroughly once a week and then fed by spraying the leaves, and that they lived in very bright conditions [5]. The mounts hung in the cooler of two greenhouse departments, kept at 14 to 20 C, which also housed the Dischidia collection, and he wrote that the high humidity left them overgrown with moss [5]. Jones hung his finished Dischidia mounts in bright shade or filtered sun and expected roots in about five weeks [1]. For Hoya imbricata Green advised watering and letting the mount dry out between waterings, decent light for flowering and occasional very weak fertilizer [5].
Orchid literature describes the watering problem on a slab. The Orchid Doctor, writing for orchids, advises watering mounts thoroughly, because water runs off them easily and wets them only superficially, evaporation is rapid and salt build-up is a good possibility [8]. It adds that tree fern, if used, must be watered well because it holds fertilizer salts as a potting mix does [8]. These entries were written for orchids; Among the hoya sources cited here, Green's 2005 note that sphagnum in a basket retains too much water and salts [6] is the one that mentions salts.
When is a pot the easier choice for a hoya?
When the air is dry. Jones, writing about Dischidia in 2008, said they can be grown potted or mounted and do quite well either way, but that pots or hanging baskets are the easiest and most common method because mounts can be difficult to maintain for growers in arid regions [2]. He based his comments on growing outside and in a greenhouse in central Florida [2]. For orchids, The Orchid Doctor notes that mounts of cork bark or ordinary lumber can be used where the humidity is usually high [8].
Green, at Kaaawa in Hawaii, grew hoyas both in pots and on boards and slabs [4], and Caspers found most of the Leiden hoyas in brown hanging containers, with some mounted [5]. For potted culture the RHS recommends a sharply draining, well-aerated compost such as an equal-parts mix that includes orchid bark [9]; the hoya soil page covers potting mixes. The Hoya imbricata page and the hoya and Dischidia comparison describe the plants most often mounted in these accounts.
Frequently asked questions
Which hoyas can be grown on a mount?
Published growers name Hoya curtisii, H. retusa, H. wayetii, H. lacunosa and H. picta as doing quite well mounted [1], Hoya imbricata on oak, tree fern or cork [5], and H. caudata, H. longifolia and H. tsangii among the mounted hoyas at Leiden [5].
What do I tie a hoya to a mount with?
Antone Jones used 40 lb test fishing line, tied at the back of the mount and wrapped around the cuttings at the nodes, because thinner line can cut the plant and thicker line is hard to knot [1].
Do mounted hoyas need sphagnum moss?
Growers disagree. Jones mounts over damp long-fibred sphagnum and replaces it every year or two [1]; Ted Green used a little moss only to start a cutting [3] and wrote that Hoya imbricata needs no moss at all [5].
How often should a mounted hoya be watered?
The sources give schedules, not a rule. Ted Green watered a mounted plant about three times a week in Hawaii [3], Caspers recorded thorough weekly watering at Leiden [5], and orchid advice warns that water runs off mounts quickly [8].
Is a mount or a pot better for a hoya?
The sources tie it to humidity. Jones found pots or hanging baskets the easiest method and warned that mounts are hard to maintain in arid regions [2]; orchid advice in The Orchid Doctor uses cork or lumber mounts where humidity is usually high [8].